woodworking table

Ive managed to make a lot of progress on this coffee table project over the last weekend. Once I got through the design and shaping of the legs, I was pretty straight forward. What I had to do next was mill and cut the rails to their rough size. Once that was done, I used the router table to cut the tenons to match the mortises in the legs. I just used a 3/4" bit set to a 1/4" height; I only cut one side of the tenon, the front, since the back will be be visible and this allows me to use a larger tenon than normal. At this point, the tenon is really just a rabbet along the front side, I simply take each tenon and lay it next to the mortise to mark the points that I need to cut off.
Once I had all the tenons cut and fit, I put the whole thing together for a dry fit.

From Coffee Table

I still have some finish sanding to do, as well as round all the edges on rails, but that should not take long. I am still trying to decide if I want to add a bead detail to the rails and legs or not; I cannot decide.

Do you find information about woodworking table are you looking for? If not, below may help you find more information about the woodworking table. Thank you for visiting, have a nice day.

About bala

Author Description here.. Nulla sagittis convallis. Curabitur consequat. Quisque metus enim, venenatis fermentum, mollis in, porta et, nibh. Duis vulputate elit in elit. Mauris dictum libero id justo.

Subscribe to this Blog via Email :

From Coffee Table

Woodworking Table

Selasa, 01 Maret 2016

woodworking table | Coffee Table Project Contd

woodworking table

About bala